Is the magic seq to enter bootloader fail as well?
Note you'll have to have your battery charged or phone may refuse to turn on at all...
Failed flash, bootloader won't load anymore.
It's dead isn't it?
![]()
Is the magic seq to enter bootloader fail as well?
Note you'll have to have your battery charged or phone may refuse to turn on at all...
@Tarwin
damned ...what have u done to get your phone dead?
On Moto E398, V635 and V710 boot loader can be forced with a short circuit on two pins ... There is any way to force boot loader on E680i through USB connector using this information ??????
How to testpoint E680i ?
hey check your battery. i remember i flashed my phone w/ only 1/3 battery and it ran out and the phone died on me. i had to borrow battery from my friend to flash. w/out the firmware, u can't recharge your phone.
I have 2 charged batteries, if I press the bootloader sequence I get no bootloader screen and pst doesn't recognise it, even though when connecting to the computer the computer will detect that SOMETHING has been connected
...
![]()
ouch Tarwin.
sorry to hear that.
Sandman successfully flashed his phone to C5AEP though.
Any luck fixing urs?
no, I'm going to go to motorola centre, there's no hope for it right now...
I had a situation like that once after a flash, after pulling out the battery countless times and slowly plugging in the charge cable it finally snapped out of it, it was as if the phone would not recognize my batteries as having charge even though they were, I thought they were bad at first but actually the batteries were fine. What happens when you plug the charge cable into the phone again and again, anything at all?
It's only a phone if you want it to be