TAPI Server is Disconnected

[antonius.arie]

Can someone here help me...

I already search this forum with the same problem,but none can solved mine.

Actually this is my friends mobile phone,and it's orginal E680 (not i), so I tried to upgrade it to E680i (if succeded I would like to upgrade again to E680G).
Here is what I've done:
- Check the phone firmware,and it's R51 48.A2P (AP) 37.B4P (BP)
- Then,directly reflash with E680i C5.A3P (AP) B0.B1P (BP)
- After that phone are succesfullly on (upgraded too),but there's another problem who always bothering me.
- I can't access all Menu (eg. Main Menu,Ph.Book,SMS,Phone), the date always displays 01-01-1979, Batt meter,sim card are disabled too...
And the most annoying thing is... it's always shown "TAPI server is disconneted", when I tap OK ,the phone will remain alive until probably 5-10minutes,then it's switch off automatically. If I don't tap the OK button after the "TAPI" message shown, 30 second later the phone will shut down by itself.
- I try to reflash back to R51, and the phone hanged at startup.
- I try reflash to E680i with C5AAP, it's still the same, same result when I flash with other FW (eg. C5ABP,C5AEP)

What's going on with this phone,do I make some mistake?? or maybe it's hardware faults??

I'm sorry if my post is too long to read.. I'm just confused.
Thx b4 n sorry for my bad English

[naset]

try to reflash again using ABP/AEP firmware with correct modded cg.mybe that can help u.

[antonius.arie]

Thx naset, I already try what you said.
Using all modded CG (threesearch,sandman,it master,e398bk,etc),but the result are still the same...

Is there any suggestion?

[naset]

try change usb port.

[jendral_hxr]

SxU

or patch cgs?

[de2amri]

i have the same problem as antonius.arie
what should i do after usb port enabled??

[jendral_hxr]

SxU

some ppl often forget to use the correct cg patch (which is specially designed for e680)

so just..
try again

[antonius.arie]

Finally... after a long journey...the phone got to be service to a Moto Service Center,and they said it's hardware fault. The bulverde is damaged and should be replaced with a new one...

Sad... sad.. the cost are very expensive...

[mecaniko]

Finally... after a long journey...the phone got to be service to a Moto Service Center,and they said it's hardware fault. The bulverde is damaged and should be replaced with a new one...

Sad... sad.. the cost are very expensive...

hello! do you have idea what is bulverde? anyone can show me a screeshot of this bulverde?

[jendral_hxr]

SxU

@antonius.arie

don't believe 'em!
about 6 months ago my big brother messed up his fw, but since he was so busy for study (he had no enough time 4 flashing) he asked service center to fix it...

then he had to replace the mainboard (waddahell!!)
sure it cost damn a lot