need help again :( flashing process

[benya274]

guys.. i really need help. something wrong with my flashing process.
i want to flash my e680i to a9p (which is promising to have a better sync via USB to outlook)

i've got PST 7.2.3 installed, with patch ran. everytime i plugged the phone, and start the pst, it shows a lot of devices installed on device manager.
so i'm ready to flash my phone right?

run MFF, and get the flash file with c5 a9p_full.shx 195MB. the erasing process(i think) runs well. by the time of the program starts to FLASH, the phone screen i got is :

RDL is running ....
2005-may-5:1

after a while, MFF confirm, the FLASH FAILED. then i try to master reset my phone, it prompts me security code which i return 000000 got error message that is INCORRECT SECURITY CODE.

anyway, my phone is still okay, but another problem is, i can only read my phone as lots of devices when is in bootloader mode. any sugestion i should do to flash my phone? what step i did wrong (btw, is it matter on flashing successfully matter if i was not changing cg33 and cg35?)

please lead me which post i should read more cuase i've read (yes but not all and in detail) found nothing about security code

[inijohan]

When MFF detects your phone as "lots of devices", point/direct to PST folder. That should do it.

[benya274]

it had been detected as motorola p2k with platform type motorola reflash Ezx.
and its been switched the device into flash mode.
on thescreen shown as

reflash flag is set
no BP_WDI before reset
start reflash code!

EZX AP bootloader
version 3.0 2004-05-18

then i've done clicking start from MFF, and some process occurs...
i think its erasing. wait until 100%...
and then fast next 100% occurs...
and i have to install next 2 drivers from PST, installed p2k.sys instead...
looks like nothing happen...
about 5 mins...
and i got new error hehehe

unable to connact to the subscriber unit. unable to get string descriptors...

anyway... jsut click2 on pst screen on MOTOROLA P2K, then occurs process till 100%... waiting... hope the falsh is working now

[benya274]

i've flashed them.. i got new red screen with CHINA MOBILE on it... but it went no where.. after the animation, then turned off... any one can help?