Usb Mass storage problem!! help plzzz!

[minh142]

i got into my misstake:
I setup Belcarra Telnet into my PC and telnet into A780, telnet and usb usage is ok in A780. But with my E680i, that only Belcarra driver is received with PC event if i set "Modem" mode or "Mass storage" mode in E680i setting!
Pleaze tell me how can i reconnect to E680i with usb mass storage mode!
(i tried flash C5 A4P and C5 AEP firmware, it's not effect anything ()
thanks !

[wickedcoma]

Have you tried removing the Belcarra drivers from your PC, and then attaching the E680i with mass storage mode enabled? If you do this, Windows should pop up the good old "Found new hardware" wizard. If you cancel out of this, the E680i should be able to be read as a mass storage device. Also, unless I am mistaken, there are some firmwares out there that will always connect the E680i in modem mode. You'll have to check that for yourself.

[luks]

If u use C5AEP with Threesearch Localization 2.0 u'll have a file named acmattach.txt in /diska. Rename it to acmattach.lin to disable auto telnet.

If u use C5AEP with Threesearch Localization 3.1 u'll have a file named autotelnet.on in /mmc/mmca1/vllp.sourceforge.net/telnet. Rename it to autotelnet.off to disable auto telnet.