How to telnet to E680

[vnbenvn]

Hi all,

I can not know how to telnet to may E680. Pls explain me.

Thanks.

[weixiang80]

there should be a FAQ ....
pls follow closely
and post any problems encountered

[JakCrow]

Weird. I got it to the point where it's asking for the USBLAN drivers, but it can't find them in the driver location. Anyone got any suggestions?


Edit: Figured it out. There are some missing \ in the FAQ that are needed.

[admin]

ah... must be coz they take it "/" as a code. damn i need to change it later

[sammy78]

ah... must be coz they take it "/" as a code. damn i need to change it later

what needed it to be changed or has it been changed..
i got to the part of mapping the drive and nothing..stuck there
thanks

[chairuou]

Finally, I can't find the place to download the USBLAN driver, FAQ is not point to its URL, anyone know how to get it ?

TIA,

[inijohan]

We've got a download section here, you know ...

[chairuou]

We've got a download section here, you know ...

thank, I got it from a friend already.

[pulp]

btw on latest linux kernels driver is built in.
I'm using 2.6.12-rc6 and usb0 interface is detected automatically when i connect the phone.
enough to bring it up with IP=192.168.1.1 and telnet to 192.168.1.2

[chairuou]

btw on latest linux kernels driver is built in.
I'm using 2.6.12-rc6 and usb0 interface is detected automatically when i connect the phone.
enough to bring it up with IP=192.168.1.1 and telnet to 192.168.1.2

Kewl, will try 2.6 later.

I still use 2.4 ( Slackware 10.1), driver compiled with few warning may come from gcc's optimization flag ?

after build the src, I did :
#modprobe usblan
it's load the module ok ( /var/log/messages tell that new driver ACM installed and new device at /dev/ttyACM0 )
but no interface like usbl0 , usb0 is available
I tried to rmmod acm ( autoloaded when I load usblan ) then re issue #modprobe usblan
the log say new driver usbnetd registered, I try ifconfig -a , ifconfig usbl0 up , ifconfig usb0 up but still not find the device
any method working around with this ?
any help are appreciated,
thanks !