HELP: Phone bricked due to improper theme Installation

[mayurrokr]

I installed a theme of .mtf format.... wen i restarted my phone it was nt properly installed... so i again repeated d process and wen i restarted my cell the motorora animation came and just stoped der.... now it only shows the same screen please help me......i m nt able to access my phone.....

[ybhavarthi]

In such case, the phone can not be reverted back to its original condition. It wont start by any means.

The only solution is to flash your phone.

But I would suggest you to take your phone to motorola service station, because flashing may void warranty.

[mayurrokr]

if i hav to flash den which is the bst firmware that u can suggest?

[Lhon0901]

Well, I suggest using .09p, it's the fastest generic firmware for me right now... But most like .08p because it's more stable...

[mayurrokr]

can u tell me wat functions i'll get in .09p.?

[Lhon0901]

Faster, and camera delay is less than .08p... Also, there is no "nested folders" limitation on .09p... What that means is that you can place any folder on the folder sub-directory... What this means that you can place a folder on /mmc/mmca/folder/folder/folder... You can create any number of sub-folders, w/c is limited on the stock .08p here... Which means I'm able to copy my .cfg files on ezx_user folder and ezxlocal and not get that "nested folders" error.

[mayurrokr]

thank's buddy..... well i m joining ur site right now

[mayurrokr]

Hey. I have downloaded the firmware. But i m not able to install the drivers when i connected my cell in bootloader mode... It is saying that your device may have problem or something like that message... Please tell me what to do now to install the drivers.....

[mayurrokr]

Problem

[Lhon0901]

Well, if you used the new driver you may get something like that... Did it proceed to flash? If not, you may have flashed with the phone turned on... I got that error when I flashed with the phone on... You need to get into "Flash Mode" first, by turning the camera off and the press the camera button, and while camera is pressed turn on phone again... Then plug the phone in "Flash" mode while RSD lite is open and the driver installed, and it should be good to go...

Hope this helps!