Flash File: EDGE Without using Radiocomm

[branny]

I'm using MotoMing A1200

[Lhon0901]

Hello!

I'm not sure if this will work on a ming, but if aksd will say that it does, then the main problem that I'm seeing is that you need to go to "flash/mbm" mode before flashing the phone... I've also had issues flashing the phone w/o going to mbm mode... Try going to mbm mobe first before flashing and it may just work...

Hope this helps!

[amneto]

for how long did u wait on the "Phone is processing data, please wait..." process?
it usually takes a while so maybe u should wait longer..

almost everything i tested on my e6 that was made for a1200 worked, lets hope it works for them too. hehe =)

[branny]

yea...i waited for almost 40minutes before i disconnected........it said "this may damage the attached device"......my heart stopped for a while as i disconnected it.....the phone didn't switch on......
then i removed the battery and put it back again..and....MIRACLE.......it was working!!
but all the settings remained same...except that my Quad-band phone changed to Tri-band
Any light??

[amneto]

oh god, just use radiocomm then...

all the rest is ok with ur firmware right?

[s.rana71]

the download link is invalid can someone provide another link