Help - No Network after flashing

[atatyu]

Thanx for all,

I think that is not possible to put encrypted firmware to phone with RSA firmware... I try every combination but it is always the same-phone part dont works.I must find full service firmware-I must find Motorola official service ((
Regards for all

[atatyu]

Is it possible to flash only BPFlex ?

[atatyu]

I have question for Linux masters:

In program EZXSysInfo-> Syslog I see one interesting part :

<4>usb_hub_port_connect_change: waiting for BP active!
<4>usb_hub_port_connect_change: waiting for BP active!
<4>usb_hub_port_connect_change: waiting for BP active!
.
.
.
<4>usb_hub_port_connect_change: waiting for BP active!
<4>usb_hub_port_connect_change: waiting for BP active!
<4>usb_hub_port_reset: Reset the port[2].
<6>hub.c: new USB device usb-ohci-3, assigned address 2
<3>usb.c: USB device not accepting new address=2 (error=-32)
<4>usb_hub_port_reset: Reset the port[2].
<6>hub.c: new USB device usb-ohci-3, assigned address 3
<4>Time 3354: Falling cases 1 d1349000
<4>usb_ipc_probe: completed probe!MSDOS FS :IO charset utf8

I am not good with Linux but I think that problem is in IPC-USB communication,because BP CPU cannot change address...Is it possible with some command to make new address mapping which AP send to BP ??? (and on this way make communication with BP)
Regards to all

[atatyu]

Hello all of you,
maybe this can be useful for somebody...
after buying new original German (not engineering release) I was try to repair old (broken by flashing) many nights,many try...
And finally I found RadioComm program- and READ some settings from working phone and WRITE this in non working and SUCCESS ! now this phone works like phone

Best regards for all