Flashing a780 problem

[cappanie]

i have a780 , tried flash using radiocomm , unable to flash, the error message as below , need to solve, i do has another firmware (flashed before works fine) , i did tried now ,this firmware also unable. please help

R52_G_0D.74.A2R_0D.C0.B1P.shx
Processing flash file...
File processing complete.
Flashing device...
FLASH FAILED: Flashing failed, NULL pointer found for RAMDL. Application may have been corrupted.
WARNING: Device successfully switched to flash mode however, the response was not as expected.
Expected Response: 0E0000000100000000088003600D00000000
Response Received: 0E0000000100000000088002600D00000000

[swifty]

use PST for flashing.

[cappanie]

use PST for flashing.

thanks,

but pst cant detect the phone , shows searching for wbu keys something.. any guides ? to use pst?

[swifty]

this is from E680, but the basics work for A780 too.

1. Install PST into its default folder.
2. Copy the patch file, crack.exe, into PST installation folder and run it.
3. There are more than 1 files to patch, so keep clicking next until done.
4. Extract the firmware, making sure you have a *.shx.
5. Put phone to USB modem mode and connect to pc.
6. Run Multiflashflex.exe located PST installation folder.
7. A bunch of drivers will be installed.
8. Select manually install driver and point to PST installation folders. All drivers will then be installed.(Don't hurry, keep clicking next, there are many drivers needed to be installed.)
9. You should now see your phone in the Device list.
10. In Flash setup, browse to the extracted E680i .shx file.
11. Click start.
12. While flashing, it may try to install more drivers. just point to PST installation folder.
13. At some moment of time, it may look hanged or dead. IT IS NOT! just wait.
14. Optional step: When it says erasing flash, copy the extracted CG33 and CG35 files into the same folder where your original .shx is located. There will be a series of files there created by PST. Just overwrite the 2 files there. This must be done before erasing flash ends.
15. Depending on whether you choose to use the 2 CG files, it will show flash passed or failed in the status.
16. In any case, dont worry. Just exit multiflashflex and plug out cable.
17. Phone will still be in blue screen. just restart it, then master reset and clear just to be sure. default security codes 000000.
18. Enjoy your new firmware.

[cappanie]

thanks members!, a big help from yours , helped me alot

cheers!

[cappanie]

tried flash a780... while flashing error message "failed to flash subcriber unit xxx something. can i know what is the problem please

[bri]

i flashed and still my touch screen not working...
do i need to reflash using diff os or send my phone to shop?

[swifty]

a reflash would not be a failure.
but it looks for me like a hardwareproblem.

[bri]

done....
i think because of the screw..too tight effecting the touch screen..
haha..dont believe it?
thats what i did...after i had open the casing, the screen is working.
but when i attached all together, it doesnt work..

mm.....now i am looking for a nonchinese a780 f/w...