INFO: Seem edit A1200 is possible thru Radiocom 10.3.1

[cmanahan1]

No, no prompt for drivers. I tried cleaning in the drivers install and then re-ran RadioComm. When do you plug the phone in, before or after you start RadioComm or does it matter?

[Tenenbaum]

No, no prompt for drivers. I tried cleaning in the drivers install and then re-ran RadioComm. When do you plug the phone in, before or after you start RadioComm or does it matter?

I plugged the phone in before starting RadioComm, but I don't think it matters. For the first time, I would plug it in before you start.

[scotty1024]

CV144, that is certainly quite the tool! Flash programmer, Flex programmer, SEEM editor (with motorola definitions already loaded!)

Thank you, I'm still trying to make it work but once I get it working it will be a very handy tool.

[cv144]

CV144, that is certainly quite the tool! Flash programmer, Flex programmer, SEEM editor (with motorola definitions already loaded!)

Thank you, I'm still trying to make it work but once I get it working it will be a very handy tool.

You are very welcome.

[Alpha43]

^ nice progress there! You see i told you people liked your find! I am still in the process also in learning all this. Maybe ill figure out a seem edit as well. ill keep posted in case i find something.
~Alpha~

[hard-case]

Just curious...under the CIT tab there's a number of functions regarding audio and vibration. One of them is AUD_LVL, which has both a get and a set option. Anyone try playing around with it, see if it might be a way to change the overall system volume? I'd try, but for some reason Radiocomm just stopped working with the phone. Get the green on both the USB taskbar icon AND radio detection, but any queries to the phone fail. I figure I'll reboot and reinstall, and if that doesn't work maybe reflash the phone again....

I also noticed a BP Gain Table and BP Param Table button set on the GSM 3 tab, but they only seem to be for getting the info, and might not be relevant at all...

[SIII]

Whattup, anyone find a way to disable the flip when Speakerphone is on? In seem 0032 0001 offset 8A bit 2: Speaker Call to End on Flip Close (1 on, 0 off)can someone try to disable this feature.. i've been trying but no luck.. thanks..

[admin]

can someone make the photo id to full screen? as usual..

[Alpha43]

All i really want is a volume gain.... Besides that im happy... And maybe the speaker phone with the flip closed... I will be one happy person when that gets achieved!
~Alpha~

[samkatta]

By the way, when the speaker is on closing the flip doesn't end the call until you press speaker button again. It is mentioned in the user manual.